• Thanks: 1
  • Thanks for the post: 1

Topic: SVP Light Not Functioning

Details - Running SVPlight 0.9.3. Have ambibox installed, with an adafruit configuration. 
SVP light was picking up ambobix for zones, but not the adafruit for hardware. 
Installed prismatik - tested it, prismatik works fine, if i run MPC-HC without SVP.

Enabled SVPlight in SVp - it found the prismatik, and testing in the setup screen - all the correct lights light when i  do the mouse over testing.
When i actually play a video however,  the lights stay on for about 10 seconds ( not capturing, just on) and then turns off.


In system tray, prismatik says "device locked by api"

Any suggestions would be appreciated.

Re: SVP Light Not Functioning

and Prismatik version is ...?

to eliminate any doubts about SVP settings and performance set it to "frames interpolation mode" = "off"

  • Thanks: 1

Re: SVP Light Not Functioning

@chainik - its Prismatik 5.10.3.
I did change SVP to "frames interpolation mode" = "off" for testing.
SVP light sees it during the "setup phase" the correct lights change during the manual and the color cycle test, b ut it has no impact when the movie actually starts, and then they shut off after like a minute.

Re: SVP Light Not Functioning

GuruKast
Prismatik 5.10.3

5.10.4 - "Fixing Adalight and Ardulight"  hmm
try it

but it may need some additional setup cause they said

WARNING: Api key will be erased by this installation. Please set it after update if you really need it

I'll post an instruction later.