You are not logged in. Please login or register.
SmoothVideo Project → Using SVP → [HELP][Win 10 64-bit]SVP doesn't detect PotPlayer
Hi! I'm new here in SVP and I'm having a problem on it, I just installed it a while ago with this guide: http://wajinshusenpai.com/watch-60-fps- … oject-svp/
and when I tried to run a video, it doesn't work. Please guide me. Thank you in advance! 
Already tried them 
I'm using the latest PotPlayer.
I also tried re-installing both of them.
-I installed 64-bit PotlPlayer
-Installed SVP and chose 64-bit too
-Did setup filter control (both Video Decoder and Filter Priority)
-Also I didn't run them on admin.
I'll try to re-install SVP again.
What do you see in the Events log: Information - Events log?
I re-installed it and got work it. But the problem now is that the Video is Delay and Stuttering, also I only got 44 avg. FPS.
I have i5-8250U and nVidia MX150 with 2GB DDR5 with 4GB Ram.
https://pasteboard.co/HhuPn9g.png
Here's the proof.
Looks like there's some problem with EVR-CP implementation in PotPlayer 
Just tried latest PotPlayer and it gives me the same poor results (low FPS, low SVP index) playing 1920*1080 video, while 1920*800 is fine.
The same video, same SVP settings in MPC-HC - still fine.
Moreover, switching to madVR in PotPlayer helps, even with shitty Intel IGP.
@Chainik, What should I do then? I want to watch anime in buttery smooth video :3
1. switch to madVR renderer in PotPlayer
or
2. switch to MPC-HC player
I tried to install madVR and switched to through it under PotPlayer's Video settings, and the results came worse. FPS became 20-30FPS with Video stuttering and delay.
@Chainik
I tried to switch to madVR, but it doesnt work too.
then you probably need to lower madVR scaling settings manually
SmoothVideo Project → Using SVP → [HELP][Win 10 64-bit]SVP doesn't detect PotPlayer
Powered by PunBB, supported by Informer Technologies, Inc.
